Automotive Electronics
Power modules, ECUs, battery control units
Low-stress, conformable thermal interface materials available in 1-part and 2-part systems, supporting thermal conductivity from 2.0 to 10.0+ W/m·K.
Select the appropriate dispensing and curing system based on your assembly process and production requirements.
Best for high-volume automated dispensing
Best for large gaps and cure-in-place applications
Traditional pads fail under tight tolerances or varied heights. Thermal gels fluidly conform to the exact architecture of your PCB.
Compare thermal gel systems by component type, thermal performance, density and curing method.
| Image | Product Series | System | Thermal Conductivity | Density | Curing Method | Key Characteristics | Action |
|---|---|---|---|---|---|---|---|
|
Pre-cured One-Component Thermal Gel |
1K | 3.5–12.0 W/m·K | 3.20–3.30 g/cm³ | Pre-cured / No on-site curing |
Ready to use, low compression stress, automated dispensing |
View Series |
|
Post-cured One-Component Thermal Gel |
1K | 3.6–12.0 W/m·K | 3.20–3.40 g/cm³ | Heat curing | Short-term room-temperature storage, cure-in-place performance |
View Series |
|
One-Component Low Density Gel |
1K | 3.5–6.0 W/m·K | 2.25–2.96 g/cm³ | Pre-cured / Ready to dispense |
Lower weight, good flow performance, automated dispensing |
View Series |
|
Two-Component Thermal Gel |
2K | 3.6–10.0 W/m·K | 3.10–3.55 g/cm³ | Room-temperature or heat curing |
Low thermal resistance, controlled curing, good gap filling |
View Series |
|
Reworkable Thermal Gel |
2K | 2.0–3.0 W/m·K | 2.90–3.05 g/cm³ | Heat curing | Peelable after curing, low residue, supports component rework |
View Series |
Power modules, ECUs, battery control units
Laptops, tablets, smart devices
Inverters, drives, power supplies
5G base stations, optical modules
High-power LED modules
Our material engineering team can customize viscosity, thermal conductivity, and cure profiles for your specific assembly line constraints.